http://support.kbs-coatings.com/ Support Forum - KBS Coatings » Topic: Mixing en Wed, 08 Sep 2010 01:35:07 +0000 http://support.kbs-coatings.com/topic/150#post-337 Tue, 17 Jun 2008 14:52:30 +0000 RP27G8 337@http://support.kbs-coatings.com/ Jim,<br /> I was using the gray and when I opened the can it was totally separated with all the solids on the bottom. I stirred it for at least 15 minutes and probably closer to 20. The number on the top of the can is 4405 and the number on the bottom is 105801. I didn't see anything on the can that described a particular lot number.<br /> When I sprayed the product it flowed out great and the final finish looks great. I am just concerned about the stirring process and the amount of solids left int he bottom.<br /><br />Thanks! http://support.kbs-coatings.com/topic/150#post-333 Mon, 16 Jun 2008 00:19:16 +0000 KBS Jim 333@http://support.kbs-coatings.com/ What color RustSeal are you using? Is there a batch # on the bottom of the can? http://support.kbs-coatings.com/topic/150#post-331 Sat, 14 Jun 2008 17:08:51 +0000 RP27G8 331@http://support.kbs-coatings.com/ I recently sprayed some RustSeal I bought. I stirred it for at least 15 minutes and still there were a lot of solids left in the bottom. Is there a better way to mix this stuff? Should I store the can upside down? I know it says not to shake but stirring alone didn't seem to get the job totally done. Any advice will be greatly appreciated! I will have before/after pics to post in about a week!